Sail Controls & Sail Trim

Sail Controls & Sail Trim

Short answer: The three basic sail controls are the kicking strap (or vang), the outhaul and the downhaul. Tighten them to flatten the sail for less power, less heel and better pointing in stronger wind. Ease them for a fuller, more powerful sail in light wind and downwind.

In this article on the basic sail controls and sail trim, I will explain how to use the basic sail controls available on all boats to set your sail trim. These sail controls should be adjusted whilst sailing your boat, each time you change the course sailed.

We will discuss the use of the following basic sail controls; kicking strap, outhaul, downhaul and sail trim.

Kicking Strap (Kicker) or Vang

The kicking strap pulls the boom down to apply tension onto the leech of the sail.  A vang does the same, but uses a mechanical arm instead of a rope and block system.

Kicking Strap Upwind

kicker upwindWhen sailing upwind, if the kicking strap is loose, the leech is allowed to curl off and the sail will be fuller.  When the kicking strap is tight, the leech is held straight and the sail is flattened.

 Kicking Strap Downwind

kicker downwindWhen sailing downwind, if the kicking strap is too loose the top of the sail will blow in front of the mast – sometimes this is helpful however it may cause the boat to become unstable and may lead to a capsize to windward.

Outhaul

The outhaul attaches to the clew and pulls the sail along the boom changing the shape of predominantly the lower third of the sail.

Outhaul Loose

outhaul looseIf the outhaul is loose the bottom third of the sail will be fuller.

Outhaul Tight

outhaul tightIf the outhaul is tight the bottom third of the sail will be flattened.

Downhaul

The downhaul tensions the luff of the sail and changes the shape of the front part of the sail attached to the mast.

Downhaul Loose

downhaul loose

If the downhaul is loose, the front portion of the sail is fuller.

Downhaul Tight

downhaul tight

If the downhaul is tight, the front portion of the sail is flattened.

Sail Trim

Using the sail controls discussed above the sail shape can be altered to suit the wind conditions. This changes the airflow over the sail, the driving force or power of the sail and the amount of drag or resistance to movement which the boat feels.
 
The following diagrams show the air flow over a sail when it is flattened off and when it is a lot fuller.

 Flat Sail

flat sail

With a flat sail the air flow is smooth and the sail is working efficiently.

  • Less power
  • Less heeling
  • More pointing

 Full Sail

full sail

While the fuller sail will provide more power the eddies over the aft part of the sail will cause drag, the wind is pulled along. If the wind were stronger the eddies would disappear and the sail would become more efficient, providing more power than the first example. It would however make the boat more difficult to hold upright and would not sail as close to the wind on a beat.

  • More power
  • More heeling
  • Less pointing

Upwind the sail needs to be flat enough to allow the boat to point well but not too flat that there is no power.  Downwind the sail needs to be full enough to develop plenty of power but not too full that the eddies discussed above slow the boat down.

You’ll practise these controls on the water in our keelboat courses in False Bay, where Levels 3 and 4 cover reefing and sail trim.

Next, read how to trim your dinghy for speed.

FAQ

What does the kicking strap do?

It pulls the boom down to tension the leech. Tight upwind flattens the sail; downwind, keep enough on to stop the top of the sail twisting forward of the mast, which can cause a capsize to windward.

When should I tighten the outhaul?

Tighten it to flatten the lower third of the sail when you are overpowered or want to point higher. Ease it for more power in light wind and offwind.

What does the downhaul do?

It tensions the luff and changes the shape of the front of the sail. Tight flattens the front of the sail; loose makes it fuller.

Should my sail be flat or full upwind?

Flat enough to point well, but not so flat that you lose power. Downwind it needs to be full enough to drive the boat, but not so full that the airflow breaks away and causes drag.

Similar Posts